NordicTrack Commercial 2950 NTL22113.0 User Manual page 18

19. Remove and discard the four indicated screws
(K).
Remove and save the four indicated 5/16" x 3/4"
Screws (1).
Hold the TV assembly near the console
assembly (E). Connect the two wires on the
TV assembly to the two wires on the console
assembly. Insert the excess wires and cable into
the console assembly.
20. Attach the TV assembly to the console assembly
(E) with the four 5/16" x 3/4" Screws (1) that you
removed in step 19. Be careful not to pinch the
wires. Start all four Screws, and then tighten
them.
See step 20b. Remove one of the nuts (L) from
the Coaxial Cable (78). Next, insert the end of
the Coaxial Cable into the indicated hole in the
Lower TV Bracket Cover (97), and reattach the
nut to the Coaxial Cable.
Attach the Lower TV Bracket Cover (97) with
four #8 x 3/4" Screws (5). Start all four Screws,
and then tighten them. Be careful not to over-
tighten the Screws.
21. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 41 and 42). Note: Extra parts may be
included.
19
Wires
K
1
Wires
20
TV
Assembly
E
78
20b
18
TV
Assembly
E
K
1
1
97
5
5
78
97
Hole
L