NordicTrack Commercial 2950 NTL22113.0 User Manual page 11

3. Insert the fan wire (A) into the left Upright (84).
Slide the Left Base Cover (89) onto the left
Upright (84), and slide the Right Base Cover
(90) onto the right Upright. Tip: You may need
to use a flat screwdriver to pull the Left Base
Cover away from the left Upright so that the
Left Base Cover will slide over the welded
plate (B). Do not press the Upright Covers
into place yet.
Slide the Upright Covers (141) onto the Uprights
(84) until they snap into place.
Then, remove and discard the four indicated
Screws (C).
4. Identify the left Tray Bracket (76), which has an
attached wire tie.
IMPORTANT: To avoid damaging the Tray
Bracket (76), do not use power tools.
Attach the left Tray Bracket (76) to the left
Upright (84) with two #8 x 1/2" Machine
Screws (13) and four #8 Flat Washers (23).
IMPORTANT: See drawing 4b. Make sure that
the Tray Bracket is attached with the Screws
through the holes shown.
Attach the right Tray Bracket (76) as
described above. Note: There is not a tie on the
right Tray Bracket.
See drawing 4b. Pull the end of the fan wire (A)
out of the left Upright (84).
3
C
141
A
B
84
89
4
Tie
76
23
84
4b
11
141
C
90
13
76
13
23
84
A
Tie
76
13
23