Slimdoorphone Services; Signalling Overview; Visitor At The Door; Telephone Caller - Linkcom Door phone User Manual

3 SlimDoorPhone Services

3.1 Signalling Overview

The unit signals acoustic conditions that may occur during operation. You can listen to the signalling
samples in the ID Manager program.
Condition
Pick up line
Hang up line
Confirm command
Dialling
Call
Conversation end warning
Enter programming (phone or PC)
Programming tone
Parameter confirmation
Programming from PC
Connection to line (Reset)
Error
Empty memory
Open lock

3.2 Visitor at the door

When a visitor presses a button the unit will lift up the line, either immediately (providing the button is
not the first number from code lock), or with delay (parameter 53) and after period given by parameter 55,
will dial the programmed phone number. The dialled number is dictated by the chosen mode, which is set
in the unit (parameter 47):
- Day/night mode = If the unit is in Day mode, it will always dial the number set in parameter 1, In
Night mode, it will always dial the number set in parameter 2. The mode switchover is set in
parameters 45,46.
- Two-Group mode = on the first press the number set in parameter 1 will be dialled. By pressing of
the same button twice, or on detection of busy tone after trying the first number, the unit will select
the number from the second group (parameter 2). The next press of the same button again selects
the number from the first group, etc........
If the button is pressed after the line has been opened (but before the call is answered), the unit will
hang up for the period given by parameter 54, lift up the line and dial the other group number.
The relay can be controlled by pressing the buttons in the combination that is set in the
preprogrammed code (parameters 32-34). The time between presses must not be bigger than that set in
parameter 53. The unit will lift up and close the corresponding relay or the period given by parameter 36 .
Then it will hang up.

3.3 Telephone Caller

A Telephone Caller is a person that is in phone connection with SlimDoorPhone.

3.3.1 Outgoing call

An "outgoing" call is a call from the unit (i.e. when a visitor presses a button). Once the visitor has
pressed a button a telephone will ring. On answering the telephone, you will be able to converse with the
visitor. 10 seconds before the maximum call duration (parameter 52) the unit will emit a tone to warn that
the call will end. The call may be extended by pressing the key as set in parameter 42. A code may be
Tones Tone frequency
–▄–■–▀– 425-850-1275
–▀–■–▄ 1275-850-425
––█–– 425
DTMF/Pulse
–■–■–■– 1275
–■–■–■– 850
––▓–▓––––– mod. 850
––█––
Silent
–■–▄–■– 1275-850-1275
425....
–■–■–■–■–■–■–
850-1275-1700...
–█–▄–■–▄–■–▄–
▓▓▓▓▓▓▓ modul 50/1250
8