Basic Description; Features; Slimdoorphone Models; Installation - Linkcom Door phone User Manual

1. Basic description

1.1 Features

Very slim module for surface mounting only. Supplied in 1, 2 or 4 button variants.
Voice communication powered from analogue telephone line only.
Pulse and tone (DTMF) dial
Two 16 digits numbers saved under each button (includes *, #, RECALL and pause)
DAY/NIGHT mode
Call prolongation by dialling * or #
Electrical (magnetic) lock compatible
Code to hang up from phone
Code to open the door by phone
3 different passwords for code lock (external code from buttons)
Optional number of rings before picking up incoming call
Optional time between code entry button-presses
Optional delay time before redialling
Optional time before dialling starts
Optional parameters for DTMF tones, Recall and Pause duration
3 default levels
Programming by remote control (DTMF) and by direct PC connection via USB cable (available
separately)
Integrated heating of printed circuit (PCB) (option)
Permanent lighting through visiting cards (option)
Earthing outlet for better protection against static electricity
Switchable audible confirmation tones

1.2 SlimDoorPhone models

Three versions are available :
1 button

2 Installation

This compact unit is fixed by 2 screws to the wall.

2.1 Opening, wiring, wall mounting and settings

2.1.1 Name card panel

1. Every unit is supplied with a special key which is used to release
the name cards on the front panel. Push the key into the hole in
the speaker grille
(see figure - 1).
2. Push the name card panel down and then push it towards to
grille (see figure-2).
3. The panel will be released. Pull it towards you to remove (see
figure – 3).
2 buttons 4 buttons
3