Advertisement
USERS MANUAL
EBS MULTIDRIVE - STUDIO EDITION
THE CONTROLS
Set to ACTIVE position if you are playing an
ACTIVE/
active instrument or if you have the pedal
PASSIVE
Switch
connected to an effects loop. If not, set this
(next to
switch to PASSIVE.
output
jack)
IT IS VERY IMPORTANT THAT THIS SWITCH IS SET
CORRECTLY FOR PROPERLY FUNCTION.
DRIVE controls the amount of gain/distortion
for the "overdrive engine". The range is from
0 dB (clean sound) up to 60 dB in maximum
position (very distorted sound).
VOLUME Controls the output volume when the
pedal is active. You can also use this control
to boost your sound.
TUBESIM activates the second tube simulator,
which adds extra harmonics with added
compression and slightly less high end attack.
STANDARD (STD) - This mode selects the standard
operation for the pedal. It bypasses the low
end for excellent bass response.
FLAT - This position selects linear gain
across the entire audio spectrum. Useful for
distorting bass sound and should be used
with fairly low Drive setting for best result.
This mode also produces some fuzz-like
sounds when used with high Drive.
FOOT SWITCH Switches the pedal on or off.
w w w . e b s s w e d e n . c o m
Advertisement
