Replacing The Embroidery Foot - Brother 888-g80 Operation Manual

■ Canceling the operation beep
a Press to display the settings screen.
b Display page 5.
c Set "Buzzer" to "OFF."

Replacing the embroidery foot

CAUTION
• Only use embroidery feet designed specifically
for this machine. Use of any other embroidery
foot may result in injuries or damage to the
machine.
a Press (Needle position button) once or twice to
raise the needle.
b Press .
• When the message "OK to automatically lower the
presser foot? " appears on the LCD screen, press
to continue.
→ The screen changes, and all keys and operation
buttons are locked (except
c Raise the presser foot lever.
d
e
f
g
h
).
Use the included screwdriver to loosen the embroidery
foot screw, and then remove the embroidery foot.
a
c
1 Screwdriver
2 Embroidery foot
3 Embroidery foot screw
Hold the embroidery foot in place with your right
hand, and then use the included screwdriver to
securely tighten the embroidery foot screw.
Slowly lower the presser foot lever.
Raise the presser foot lever to check that the
embroidery foot is securely attached.
Press to unlock all keys and buttons.
Care and Maintenance
b
Appendix A-5
A