Installation - JVC DT-V17L3R Instructions Manual

Installation

CAUTION
• Do not rest your arm on the monitor or lean against the monitor.
• Do not touch the LCD panel when installing the monitor.
• Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor
or injury.
You can place the monitor in the following two ways when using it on the supplied stand.
You can tilt the monitor as follows.
Monitor
About 12°
Stand
0°
About 8°
• When the monitor is not tilted (0°), the
guidelines align as illustrated below.
Guidelines
• You can select the stand height—higher position or
lower position (☞ "To adjust the stand height" on
page 5).
CAUTION
• Be careful not to pinch your fingers in the gap between
the monitor and the stand.
• When the stand plate is attached to the lower
position of the stand body, you cannot tilt the monitor
downward.
When the stand plate is attached to the higher
position of the stand body (☞ "To adjust the stand
height" on page 5), you can place the monitor as
illustrated below.
1
Remove the screws on the right side of the stand
(see the illustration below), then lift the stand up
by about 144°.
About
144°
Screw
(silver)
2
Attach the removed screws and place the monitor
as illustrated below.
• To place the monitor as illustrated on the left again,
remove the screws on the right side of the stand,
return the monitor angle to 0°, then reattach the
removed screws.
CAUTION
• When lifting up the stand...
– lay the monitor on a cloth with the LCD panel
facing down to prevent the LCD panel from being
damaged.
– be careful not to pinch your fingers in the moving
parts.
• Make sure of lifting the stand up until it stops (about
144°); otherwise the monitor may fall over.
• Place the monitor on a mat to avoid scratching the
table surface.
• Do not lift up the stand when the stand plate is
attached to the lower position of the stand body.
To detach the stand
CAUTION
Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.
Attachment screws
Screw holes for stand attachment
Monitor
To install the stand
When attaching the stand to the monitor, insert the guides of the stand into the guide holes on the monitor to
place the stand in the correct position. Then fix the stand firmly with the attachment screws.
Guides
Screw holes
for stand
attachment
Stand plate
Stand body
4
Stand body
Guide holes
Monitor