Table of Contents
Advertisement
show debug-log
Note –
advice of a service technician.
Shows the debug logs for the Storage Controller (SC), the Management Controller
(MC), the semaphore trace, task logs, or all of them. If no logs are specified, all logs
are shown.
For details about using
show debug-log-parameters
Note –
advice of a service technician.
Shows which debug message types are enabled (on) or disabled (off) for inclusion
in the Storage Controller debug log.
For details about using
guide.
show enclosure-status
Shows the status of system enclosures and their components. For each attached
enclosure, the command shows general SCSI Enclosure Services (SES) information
followed by component-specific information.
For details about using
122
R/Evolution 2000 Series Troubleshooting Guide • May 2008
This command should only be used by service technicians, or with the
show debug-log
This command should only be used by service technicians, or with the
show debug-log-parameters
show enclosure-status
, see the CLI reference guide.
, see the CLI reference
, see the CLI reference guide.
Advertisement
Table of Contents
Troubleshooting
