Description Of Error Codes And Causes; Main Common - Electrolux W565H Service Manual

Troubleshooting
71

13.3 Description of error codes and causes

MAIN COMMON

10:1 INTERNAL ERROR CPU TACHO
Tacho input on CPU delivers values that is out of range.
Recommended actions:
1. Run motor on highest possible speed in service mode. Check input value for RPM speed.
2. Replace defective component.
10:11 REAL TIME CLOCK OUT OF ORDER
The real time clock is used by the control system for delayed start, measuring time, power failure,
error codes, etc.
Upon power on, the communication with the internal real time clock in the control system is
established. In case this fails, this error occurs
Recommended actions:
1. Power off the machine for 1 minute and try again.
10:13 INITIALIZATION FAILED
The error code is shown if the hardware initialization has failed to initialize within 15 seconds
after power on.
Recommended actions:
1. Press the control knob/start button to retry.
2. Upload a new software that matches the machine configuration and try again.
10:13 MACHINE STOP
This message is shown if input for MACHINE STOP is activated.
This is not an error code but is handled in the same way.
Recommended actions:
1. Reset the Machine Stop Button.
2. Press the control knob to confirm machine stop. Machine will revert to Idle mode.
10:13 EMERGENCY STOP
This message is shown if input for EMERGENCY STOP is activated. This is not an error code but is
handled in the same way.
Recommended actions:
1. Reset the Emergency Stop Button.
2. Press the control knob to confirm emergency stop. Machine will revert to Idle mode.