Error Codes - Electrolux W365H Operating Manual

Error codes

If the power supply to the machine should be cut
while it is working, the programmer has a
memory which stores the program at least one
minute.
The machine will restart automatically once the
Fig.
power supply is restored.
1
When error code occur a new start attempt can
be made directly by activate the START-button.
Resetting the wash program and error code, in
order to choose a new wash program, can be
done by pressing the START-button min. 10
seconds.
Error code Cause/Action
01E Acknowledgement signal for water level not received within time
allowed.
02E Door status acknowledgement signal not received during program
operation.
03E Door lock acknowledgement signal not received within time
allowed.
04E Temperature sensing device indicates temperature below -5°C
(continuity fault).
05E Temperature sensing indicates temperature above 98°C (short-
circuit).
06E Water level above parameter set, on program start-up.
07E Water level above parameter set for safety, during program.
08E Increase in water temperature is below parameter set.
10E Water level is above parameter set (10 scale units) after water
discharge.
12E The program control unit cannot read the program EPROM.
13E The program control unit receives no response from the motor
control unit.
14E Water level system not calibrated.
Error codes
1
3:1
2243 A
438 9025-71/01