Description Of Fault Codes And Causes - Electrolux W455 H Service Manual

Description of fault codes and causes

Fault code 01, NO WATER
This fault code is generated by the programming CPU card.
When filling with water, the level specified by the wash program must be
attained within a certain time. This time is normally set to 10 minutes but
can vary depending on the type of machine and the software. If the filling
time eceeds the maximum allowed filling time, fault code 01 will be
displayed.
Long filling times can be caused by a blocked filler valve, defective filler
valve, a break in the cable between the filler valve control board, defective
valve control board, leaking level system, etc.
Fault code 02, DOOR OPEN
This fault code is generated by the programming CPU card. The fault code
can only arise during an on-going wash program.
This fault code will be displayed
door has been opened during an on-going wash program.
This can be caused by a bad or defective door lock, loose cable to door
lock, problem with door lock edge connection.
Fault code 03, DOOR LOCK ERROR
This fault code is generated by the programming CPU card. The fault code
can arise at program start. If the door lock doesn't lock within a certain time
after program start, this fault code will be shown.
This fault code will be displayed if the door lock for closed door signals that
the door has been unlocked during an on-going wash
This can be caused by a bad or defective door lock, loose cable to door
lock, problem with door lock edge connection.
Troubleshooting
if the input for closed door signals that the
program.
23
438 9047-81/02