Error Messages - Nikon COOLPIX P51 0 Quick Start Quide

Error Messages

The following table lists the error messages and other warnings displayed on the
monitor, as well as the solutions for dealing with them.
Display
O
(flashes)
Battery exhausted.
Battery temperature
high
The camera will turn
off to prevent
overheating.
Q
(flashes red)
Please wait for the
camera to finish
recording.
Memory card is write
protected.
Not available if Eye-Fi
card is locked.
This card cannot be
used.
This card cannot be
read.
Clock not set.
Set date and time.
Battery exhausted.
Charge or replace the battery.
Battery temperature is high.
Turn off camera, and allow battery to cool down before
resuming use. Five seconds after this message appears, the
monitor is turned off, and the power-on lamp, the AF/access
lamp and the flash lamp flash quickly. After the lamps flash for
three minutes, the camera turns off automatically, but you can
also press the power switch to turn it off manually.
Inside of the camera has become hot. The camera turns off
automatically.
Leave the camera off until the inside of the camera has cooled
and then turn it on again.
Camera cannot focus.
• Refocus.
• Use focus lock.
Camera cannot perform other operations until recording is
complete.
Wait until message clears from display automatically when
recording is complete.
Write-protect switch of the memory card is in "lock" position.
Slide the write-protect switch to "write" position.
Write-protect switch of Eye-Fi card is in "lock" position.
Slide the write-protect switch to "write" position.
Error accessing Eye-Fi card.
• Use an approved card.
• Check that the terminal is clean.
• Confirm that memory card is correctly inserted.
Error accessing memory card.
• Use an approved card.
• Check that the terminal is clean.
• Confirm that memory card is correctly inserted.
Cause/Solution
A
E75
18, 20
25
–
32
86
–
–
–
23
22
22
23
22
22
E101