Table of Contents
Advertisement
Features That Can Be Set Using the Multi Selector
Using the Flash (Flash Modes)
You can shoot pictures with a flash by raising the flash. You can set a flash mode that
suits the shooting conditions.
1
Press the
flash.
• When the flash is lowered, the flash mode is fixed at W
(off).
2
H
m
Press
(
3
Use the multi selector to select the desired
mode and press the k button.
• See "Available Flash Modes" (A67) for more
information.
• If the k button is not pressed within a few seconds,
the selection will be canceled.
• When U (auto) is applied, D is only displayed for
a few seconds even if monitor indicators (A15) are
turned on.
4
Frame the subject and take a picture.
• The flash lamp indicates the status of the flash when
the shutter-release button is pressed halfway.
- On:
- Flashing: The flash is charging. The camera cannot
- Off:
• If the battery is low, the monitor will be turned off while
the flash is charging.
66
m
(flash pop-up) button to raise the
flash mode) on the multi selector.
The flash will fire when you press the
shutter-release button all the way.
take pictures.
The flash will not fire when a picture is
taken.
Auto
Advertisement
Table of Contents
