Camshafts; Jackshaft; Crankshaft; Flywheel - Lotus Europa Workshop Manual

Bore in cylinder head - Std.

Camshafts

Journal diameter
End Float
Bearings - Number
- Type
- Running clearance
Cam followers:
Bore in head
Outside diameter
Follower to head clearance

Jackshaft

Bearings - Number
- Type
- Length - Front
- Running clearance
Journal diameter
End float

Crankshaft

Balance
Diameter - Main journals
-Crankpin
End float - Dimension
- Controlled by
Bearings - Number
- Type
- Running clearance
Maximum undersize for re-grind

Flywheel

Maximum run out (lateral)
Starter ring gear - Run out - Lateral
----------------------------------------------------------------------------------------Section Updated: 6/27/2009 9:01 AM at http://www.lotus-europa.com ----------------------------------------------------------------------------------------
- O/size
- Centre
- Rear
- Radial
12.674/12.687 mm. (.499/.4995 in.)
12.872/12.839 mm. (.505/.5055 in.)
25.4/25.413 mm. (1.000/1.0005 in.)
.076/.254 mm. (.003/.010 in.)
5
Steel backed white metal
.013/.050 mm. (.0005/.002 in.)
34.925/34.940 mm. (1.375/1.3756 in.)
34.904/34.91 2 mm. (1.3742/1.3745 in.)
.013/.036 mm. (.0005/.0014 in.)
3
Steel backed white metal
19.05 mm. (.75 in.)
16.26 mm. (.64 in.)
19.05 mm. (.75 in.)
.025/.050 mm. (.001/.002 in.)
39.624/39.637 mm. (1.560/1.5605 in.)
.063/.190 mm. (.0025/.0075 in.)
Within 14.42 gr. cm. (2 oz. in.)
53.987/54.000 mm. (2.1255/2.1260 in.)
49.199/49.211 mm. (1.9370/1.9375 in.)
.076/.203 mm. (.003/.008 in.)
Thrust washers on centre main bearing
5
Steel backed, lead bronze with lead overlay
.038/.076 mm. (.0015/.0030 in.)
.762 mm. (.03 in.)
.101 mm. (.004 in.)
.406 mm. (.016 in.)
.152 mm. (.006 in.)
- 5 –