Epson TM-H6000 Service Manual page 56

Confidential
8. Fasten the frame plate to the right and the left frames using two screws. Sandwich the right
and left frames and tighten the screws.
9. Fix sensor circuit board A to the right frame with one screw.
10. Install the thermal print head assembly onto the main body.
538 E-ring(1.5)
537 Hexagon nut
502
515
screw(C.B.P-tite,3X8)
Left frame
546
Paper cutter cover
assembly
11. Place in the head press springs into the press plate.
12. Install the press plate and the head press springs into the thermal print head assembly with
two screws.
13. Attach the intermediate circuit board to the right frame with one screw.
14. Insert the reduction gear into the reduction gear shaft. The larger diameter part should be
on the inner side.
15. Attach the receipt paper feed motor to the motor frame with two screws.
16. Attach the receipt paper feed motor to the left frame. Insert the reduction gear shaft into the
motor frame hole.
Rev. A
502
screw(C.B.P-tite,3X8)
510
Paper detector
assembly
517
Frame plate
520 Relaxation plate
513 Head caution seal
512
N.E. detector adjustment screw
526 Paper holder
547
Relaxation plate
fixing plate
Figure 2-23
TM-H6000/H6000P Service Manual
540
screw(C.B.S-tite F,3X6)
543
Cover open detector
lead wire
541
Sensor
circuit board
assembly
514
Right frame
502
screw(C.B.P-tite,3X8)
540
screw(C.B.S-tite F,3X6)
Disassembly and Assembly 2-27