Epson TM-H6000 Service Manual page 44

Confidential
14. Lubricate the lever motor reduction gear shaft.
15. Use one E-ring to attach the lever motor reduction gear to the lever motor reduction shaft.
The arrow on the lever motor deceleration gear should be facing to the outside.
16. Lubricate the inside of the sub slip feed lever shaft in two places. See Appendix G for a
lubrication diagram.)
17. Lubricate the sub slip feed shaft holder.
18. Lubricate the form stopper shaft rotating unit in two places.
19. Lubricate the main sub assembly frame and sub slip feed roller in two places where they
contact.
20. Lubricate the sub slip feed roller and main sub assembly holder.
21. Lubricate the area of contact of the stopper drive shaft and the form stopper.
22. Lubricate the lever drive cam.
689 E-ring(2.3)
666 Sub slip feed
roller assembly
616
Lever drive shaft
gear
23. Attach the slip B.O.F. detector assembly to the slip guide lower frame (type B) with one
screw .
24. Insert the lead wire.
Rev. A
614 Lever motor reduction gear
613 Lever drive motor
detector plate
Figure 2-14
TM-H6000/H6000P Service Manual
639 Slip drive gear
Disassembly and Assembly 2-15