Fcc Notice - SoftBank 102SH User Manual

112

FCC Notice

This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.
FCC Information to User
This equipment has been tested and found to comply with
the limits of a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation; if this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician
for help.
FCC RF Exposure Information
Your handset is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The guidelines are based on standards that were developed
by independent scientific organizations through periodic
and thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the
safety of all persons, regardless of age and health. The
exposure standard for wireless handsets employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg.
The tests are performed in positions and locations (e.g. at the
ear and worn on the body) as required by the FCC for each
model.
The highest SAR value for 102SH and 102SHⅡ as reported to
the FCC when tested for use at the ear is 0.315 W/kg, and
when worn on the body in a holder or carry case, is 0.576 W/
kg.
This device was tested for typical body-worn operations
with the back of the handset kept 1.0 cm from the body.
To maintain compliance with FCC RF exposure requirements,
use accessories that maintain a 1.0 cm separation distance
between the user's body and the back of the handset. The
use of beltclips, holsters and similar accessories should not
contain metallic components in its assembly.
The use of accessories that do not satisfy these requirements
may not comply with FCC RF exposure requirements, and
should be avoided.
The FCC has granted an Equipment Authorization for this
model handset with all reported SAR levels evaluated as
in compliance with the FCC RF emission guidelines. SAR
information on this model handset is on file with the FCC
and can be found at http://www.fcc.gov/oet/fccid
Display Grant section after searching the corresponding FCC
ID (APYHRO00157).
Additional information on Specific Absorption Rates (SAR)
can be found on the Cellular Telecommunications & Internet
Association (CTIA) Website at http://www.ctia.org.
under the