Datalogic Falcon 4420 48-Key Quick Reference page 13

Figure 5. Installing the Battery Pack
If you remove the battery pack or the battery fails, you have about 30 minutes to swap
in a new battery pack or charge the battery pack before the backup battery fails (if the
backup battery has been fully charged).
Quick Reference Guide
Battery Door Latches
Battery Door
Battery
Strap Studs
Cover Plate (unit may have Handle here instead)
2. Turn the battery door latches to unlock the battery door. Remove the
door.
3. Insert the battery pack with the pull tab on the outside and the bat-
tery contacts aligned with the matching contacts inside the battery
compartment. The battery pack has a keying feature on one side to
prevent incorrect installation (refer to Figure 5).
4. Replace the battery door by inserting the bottom tab into the slot. If
the battery pack is installed incorrectly, the door will not seat properly.
5. Rotate the battery door latches on the battery door towards the base
of the unit.
6. On the 441X, replace the handstrap hook on the strap stud at the base
of the unit.
Plastic Pull Tab
Unhook/hook Strap As Needed
Powering the Falcon
Falcon
11