Buzzer - Miele G1574 Operating Instructions Manual

Additional functions

Buzzer

An audible tone sounds at the end of
the programme or if there is a fault.
You will hear the buzzer at the end of a
programme in bursts of five with a short
pause in between. The buzzer will
continue to sound for up to an hour if
you do not switch the dishwasher off.
In the event of a fault, the buzzer will
sound continuously for up to two
minutes if you do not switch the
dishwasher off or correct the fault.
The buzzer is activated as standard at
the factory.
You can deactivate the buzzer at the
end of a programme if you wish. The
buzzer will still sound if there is a fault,
even if it has been deactivated.
^ Open the door.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button U .
Keep the programme selector button
pressed in until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
42
^ Press the Turbo/Tab button four
times.
The Tab indicator light will flash briefly
four times at intervals.
The message flashing in the Time left
display shows whether the buzzer at
the end of the programme is activated
or deactivated.
– "p 1": The buzzer is activated.
– "p 0": The buzzer is deactivated.
^ To change the setting, press the
programme selector button.
The setting is now stored in memory.
^ Switch the dishwasher off with the Off
button V.