DeWalt D55154 Instruction Manual page 24

CODE POSSIBLE CAUSE POSSIBLE SOLUTION
24 Fuse blown, circuit breaker tripped 1. Check fuse box for blown fuse and replace as
necessary. Reset circuit breaker. Do not use a fuse or
circuit breaker with higher rating than that specified
for your particular branch circuit.
2. Check for proper fuse. Use only a time delay fuse.
3. Check for low voltage conditions and/or proper
extension cord.
4. Disconnect the other electrical appliances from circuit
or operate the compressor on its own branch circuit.
25 Tank pressure exceeds pressure Switch Cut:in pressure Motor Will Start aut0matically when tan k preSsUre d tops
i below cut-in pressure of pressure switch:
26 Pressure release valve on pressure switch has not Set the On/Off switch to OFF. If the valve does not open,
unloaded head pressure replace switch. Contact a DEWALT factory service center
or a DEWALT authorized service center.
24