Erase Sensors - Konig SEC-ALARM200 User Manual

ADVANCED PROGRAMMING
Step Keys

3 [0] to [9]

4
SENSOR 1
Zone 1 Button [1]
Zone 2 Button [2]
Zone 3 Button [3]
Zone 4 Button [4]
Zone 5 Button [5]

Erase Sensors

Proceed to the following to erase a sensor.
Step Keys

1 [PROG]
[MPIN]

2 [9]

3 To erase an
occupied
sensor, press
[1] to [0].
Function
Select sensor Refer to the diagram
location below to select the
sensor location, which
includes the zone and
sensor number.
Trigger sensor Once the sensor is
activated, the signal will
be transmitted to the
Control Panel which
will be stored.
SENSOR 2
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
Function
Enter Enter master
Programming password to
mode programming mode
Select erase
remote
programming
Select the sensor Refer to the table
you would like to below to select the
erase remote location.
23
Description
After you have selected the
zone, that zone LED will be
on.
You will hear [Zone X]
Sensor Y Accepted], where X
and Y are the zone and sensor
numbers you have selected.
This row:
Buttons for Sensor 1
Zone LED: Flash once
This row:
Buttons for Sensor 2
Zone LED: Flash twice
Description
3 beeps for valid password. 1
long beep for invalid
password.
After [9] is entered, some
zone LEDs will flash or stay
off. The zone LEDs represent
whether that zone is
occupied by any sensor.
**See Table D below.
After you have selected the
sensor, you will hear 3 beeps
and verbal confirmation
[Zone X Sensor Y Empty
Memory], where X and Y
Enter Programming mode
are the zone and sensor
numbers you have selected.
Note
Note