System Status; Arming The System - Konig SEC-ALARM200 User Manual

System Status

The control panel continuously monitors the system status as well as all the sensors status. It will monitor
occurrences such as triggered sensors, low battery sensors, malfunction sensors, or phone line failure etc.
In order to check the system status, user can press the "Status" button on the control panel, voice
announcement will be made regarding the system and sensor status. When the "Status" button is pressed,
you will be notified if any of the following events is occurring:
- System armed or disarmed
- Any triggered sensors
- Any sensors with low battery warning
- Any sensors with failure warning
- Phone line failure
Refer to page 12 for more details regarding system failures

Arming the System

You should arm the system when you are the last person to leave the house. By arming the system, the
control panel will call the preprogrammed emergency phone numbers and the siren will sound when break-in
occurs.
Caution: Only arm the system when nobody is expected to be inside the premises.
When someone is expected to be within the premises, the system should not be armed.
To arm the system, follow the procedures below:
OR
1. Press [Arm] on the control
panel or keychain remote.
1. Press [Arm] button on the control panel when no sensors are triggered. You can also use the keychain
remote to arm the system by pressing arm button on the remote.
Note:
- The control panel cannot be armed if there are triggered sensors. Make sure all sensors are in closed
position, i.e. (close all doors, windows, no movement should be detected etc).
- The control panel can be armed if there are sensors with low battery or failure warning.
2. After pressing the "ARM" button, the "ARM" LED will flash and you will have 45 seconds to leave the
premises, this is called the exit delay. You will hear beeping during the exit delay interval. The beeping rate
will change from slow to fast, the faster the beep rate, the less time you have left to leave the premises
before the siren sounds.
OPERATION
Exit delay 45 seconds
Beep Beep
2. Leave the premises 3. After 45 seconds.
within 45 seconds. System will be armed.
10
45 seconds
later ARM
System
LED on
Armed