Disarming Under Duress - Konig SEC-ALARM200 User Manual

Wierless alarm system
Hide thumbs Also See for SEC-ALARM200:
Table of Contents

Advertisement

Available languages

Available languages

2. You need to reset the sensor manually by triggering it twice, i.e. open and then close a door / window
sensor, or walk in front of the motion sensor. The LED representing that sensor will stop flashing after it
receives the signal from the sensor.
3. You must now enter the password again on the control panel or press the disarm button on the keychain
remote, as an acknowledgement of the alarm event. This will set the control panel back to standby mode.

Disarming under Duress

If you are forcibly compelled to disarm the control panel, you may enter the Duress Password. Entering the
duress password will terminate the entry delay, i.e. no more entry delay beeping. But the control panel will
silently call the emergency phone numbers for help. The called party will hear the voice announcement
"System Panic".
Note:
- The default duress password is [3838].
Panic
Pressing the panic button on the control panel or keychain remote will
cause the siren to sound and outgoing calls will be made to the
preprogrammed phone numbers, "System Panic" will also be announced.
This can be used in any emergency situation.
To stop the siren and disarm the system, user can enter a valid password,
or press the disarm button on the keychain remote. This will terminate the
siren and the control panel from calling the rest of the emergency phone
numbers.
- Control other Skylink receiver
such as Garage Door Receiver
System Failure
Control Panel constantly monitors itself and its sensors. If there are any trouble conditions, the control panel
will advise the user. These trouble conditions include:
- Phone Line Failure
- Sensor Failure (loss of supervisory signal)
- Low Battery – Control Panel
- Low Battery – Sensors
Phone Line Failure
When the phone line is disconnected or malfunctions, the control panel will instantly notify the user by:
1. Both Power [PWR] and Program [PROG] LEDs will flash together;
2. Voice announcement "Phone Line Failure" will be played.
OPERATION
PANIC
AUX
12
ARM
DISARM
OR

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents