Remote Operation By Telephone - Konig SEC-ALARM200 User Manual

1. The LED on the keychain doesn't flash or on when a key is pressed; or
2. The operating range starts to decrease.
To replace the battery:
1. Undo the two screws on the back of the transmitter.
The bottom case will then come off.
2. Using a small screwdriver or pen, pry out the old battery from one end.
3. Place the new battery in position. A diagram in the battery compartment indicates
which end is positive and which is negative.
4. Close the battery cover and reinsert two screws.
Receiving the Emergency Call
If you are on the list as one of the recipients of the emergency call, you should read the following instructions
carefully. You should also notify all the persons you will be calling so they know how to react when they
receive the emergency call.
The control panel will call you when there are emergencies such as break-ins, smoke, fire events, or someone
at home needs assistance.
1. When the phone rings at the calling location, the person who answers the
phone will hear a message related to the emergency events, such as "System
Panic", or "Zone 1 Sensor 1 Triggered" etc. This message may be repeated
several times depending on how it was programmed.
2. After the message has been repeated for a certain number of times, the control
panel will ask for a valid password, you will hear "Enter Password".
3. Enter the 4-digit password to have access to the control panel. If a valid
password is accepted, you will hear "Password Accepted", otherwise, you will
hear "Password Failure".
4. After entering the correct password, you can follow the "Phone Command"
instructions to perform the required tasks, such as disarm, turn on / off devices
or check the system status etc. For further information of how to control the
system remotely, please refer to the next section, "Remote Operation by
Telephone".

Remote Operation by Telephone

The control panel can be operated while you are away from home. You can have access to the control panel
with any touch tone phone to perform a variety of operations, listed below.
- Arm
- Disarm
- System status
- Disconnect
OPERATION
14
-
+
Zone 1
Sensor 1
Triggered
Enter
Password
- Arm
- Disarm
- Check status
- Control lighting etc
- Disconnect