Quick Start - Panasonic SDR-S10P Operating Instructions Manual

Setup
o
MENU
Quick start
When quick start is ON the battery power
is still being consumed, even when the
LCD monitor is closed.
This unit will resume recording/pause
mode about 1.7 seconds after the LCD
monitor is reopened.
• When in quick start standby mode,
about half of the power used in
recording pause mode is being
consumed, so the recording time
will be reduced.
• This is only activated in the
following cases.
- While using the battery
When the mode dial is set to • or
o
and an SO card is inserted.
- While using the AC adaptor
When the mode dial is set to • or
0,
quick start can be used even if
an SO card is not inserted.
1
Press the MENU button then
select [SETUP]
~
[QUICK START]
~
[ON] and
then press the cursor button
in the center.
How,tol-urnlhe power on
andoffwith
,the·~L..CD
monitor
The status indicator goes off and the
power turns off. (If [QUICK START] is set
to [ON], the unit goes into quick start
standby mode and the status indicator
flashes green.)
• The power will not turn off while
recording motion pictures even if the
LCD monitor is closed.
• To turn off the power
Close the LCD monitor.
The status indicator lights and the power
turns on.
The power can be turned on and off with
the LCD monitor when the mode dial is
set to • or
O.
• To turn on the power
Open the LCD monitor.
Set the mode dial to OFF when the
unit is not being used.
· " "." ·,···_·_··>·.··
·C_f~_~-'.·
..,....,·.. . \ · -··'w· ·
-.·,·.·.w·. -.--.-"..
t···
·-',".",·-.-.-V.N·WA,-.-.".-.-"., .-.-..- .. ....•.......-- ....••.....
-."h'~.,
-.-.-,. .. -.-.-- -
r' -
-"' r ' "
29
VQT1D97