Axis P1353–E User Manual page 65

AXIS P1353–E Network Camera
Troubleshooting
Motion Detection triggers unexpectedly
Changes in luminance
No audio
Incorrect setup
Poor audio quality
Stuttering
Unsynchronized audio and
video using H.264
Distorted audio
Feedback loops
Storage and disk management problems
Storage disruption
Video cannot be recorded
SD card cannot be mounted
Motion detection is based on changes in luminance in the image. This means that if there are
sudden changes in the lighting, motion detection may trigger mistakenly. Lower the sensitivity
setting to avoid problems with luminance.
Check the sound card in the computer. Ensure that mute is not selected and that the volume
settings are correct.
Check that Enable audio support is selected under Setup > System Options > Security > Audio
Support.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Reduce the number of listeners and viewers. Decrease image resolution and compression.
Synchronize the product's date and time settings with an NTP server. Go to Setup > System
Options > Date & Time.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Feedback loops might appear in full-duplex mode. Try moving the microphone or the speaker, or
use half-duplex mode instead.
A storage disruption alarm is sent if a storage device is unavailable, removed, full, locked or if other
read or write problems occur. To identify the source of the problem, check the System Log under
System Options > Support > Logs & Reports. Depending on the problem, it might be necessary to
re-mount the storage device.
For information on how to set up a storage disruption alarm, see Events on page 40.
Check that the SD card is not write protected (that is, read only).
Reformat the SD card and then click Mount.
NOTICE TICE
NO NO TICE
Formatting the card will remove all content, including all recordings, from the SD card.
65