Operation Characteristics - Interlogix 600-6520-95 Manual

Operation characteristics

Table 2: Operation characteristics
LED Display
Normal operation Green Power
LED flashes
every 30
seconds.
Carbon monoxide Red Alarm LED
alarm flashes with
beeps.
Low battery / Red Alarm LED
low battery hush flashes every
60 seconds.
Alarm end-of-life Red Alarm LED
indicator flashes two
times every 30
seconds.
Trouble/service Red Alarm LED
alarm flashes every
30 seconds.
Error condition Red Alarm LED
constantly on.
Test mode Red Alarm LED
flashes with
beeps.
a
Tamper Red Alarm LED
flashes every
30 seconds.
a. Local indication starts 3.5 minutes after the unit is removed from the mounting plate.
466-2411 REV A May 2011
Alarm sound Unit status
None. Normal DC
operation (sensing
no CO) and with
good batteries.
Four quick beeps, Alarm condition.
5 seconds Dangerous
silence, concentrations of
repeating. CO detected.
One quick beep Batteries need to be
every 60 replaced.
seconds.
Two quick beeps End of CO alarm
every 30 life.
seconds.
One quick beep Unit is in trouble
every 30 condition.
seconds.
Constant alarm. Very low battery or
unit malfunction.
Four quick beeps, Normal operation
5 seconds when Test/Hush
silence, repeated button is pressed.
once.
One quick beep Unit is in tamper
every 30 condition.
seconds.
Control panel status Recommendation
Normal operating None.
condition.
Alarm condition. See "Alarm procedure" on page 8.
Trouble condition, Replace all three AA batteries.
trouble beeps every 60
Press Test/Hush button and release.
seconds.
This will silence the low battery audible
chirp between 8 and 11 hours allowing
for a more convenient time to replace
the batteries.
Not applicable. Press the Test/Hush button and
End-of-life events are release. This will silence the end-of-life
not communicated to signal for up to three days. After three
the control panel. days, the unit will resume end-of-life
chirps. Hush mode will silence the
alarm ten times or up to 30 days. After
30 days, the unit can no longer be
hushed. Replace the CO alarm
immediately. The unit will not respond
to CO.
Not applicable.
Replace batteries. If condition
Trouble/Service events continues, unit has malfunctioned.
are not communicated Replace immediately. Unit will not
to the control panel. respond to CO.
Not applicable. Replace batteries. If condition
Error conditions are continues, unit has malfunctioned.
not communicated to Replace immediately. Unit will not
the control panel. respond to CO.
Sensor test mode CO not detected. Alarm for test
purposes only.
Not applicable. Place alarm body back onto mounting
Tamper events are not plate. If condition continues, unit has
communicated to the malfunctioned. Replace immediately.
control panel.
5