Heat & Glo SL-550TR-E Owner's Manual page 67

3 3
Figure 6 Figure 6
Swing knot towards log #3 Swing knot towards log #3
Figure 8 Figure 8
Log #4: Locate the notch at the end of log # 4. Mate the notch
with the tine as shown above. The top end of log #4 should
rest between the end of log #2, and the bump located on log
#1. Swing the knot on log # 4 towards log #3.
Figure 10 Figure 10
Step #6: Apply the supplied lava rock as shown above.
Take care to ensure that no lava rock is placed past the line
indicated in Figure 1.
PIN HOLE PIN HOLE
Bump Bump
4 4
Mate notch with grate tine Mate notch with grate tine
Lava Rock Lava Rock
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. U • 7/12
Log should touch lava rock retainer Log should touch lava rock retainer
3 3
Mate shoulder screw with pin hole Mate shoulder screw with pin hole
Figure 7 Figure 7
Log #3: Locate the pin hole on the underside of log #3.
Mate the pin hole with the shoulder screw located on the
burner top. Push the left end of log # 3 toward the back of
the fi rebox until it touches the lava rock retainer.
Figure 9 Figure 9
Log #5: Locate the notch at the end of log # 5. Mate the
notch with the far right grate tine. The top end of log # 5
should rest on the right side of the "bump" as shown above.
You may need to move log #4 slightly.
SL-550TR-E
SL-550TV-E
Log 1 SRV2115-701
Log 2 SRV2115-702
Log 3 SRV2115-703
Log 4 SRV2115-704
Log 5 SRV2115-705
Bump Bump
5 5
Mate notch with grate tine Mate notch with grate tine
SL-750TR-E SL-950TR-E
SL-750TV-E SL-950TV-E
SRV2118-701 SRV2121-701
SRV2118-702 SRV2121-702
SRV2118-703 SRV2118-703
SRV2118-704 SRV2121-704
SRV2118-705 SRV2121-705
67