Product Introduction; Models; Key Features; Front Panel - Lindy 25021 User Manual

Fast ethernet switch twenty-four (24) ports 100/10mbps fast ethernet switch
Table of Contents

Advertisement

2

PRODUCT INTRODUCTION

2.1

Models

The Switch is a multi-speed, versatile network device combining both standard and "Big-Pipe" ports under the same hood.
The Switch is a twenty-four (24) 100/10Mbps RJ-45 UTP/STP ports switch.
2.2

Key Features

Twenty-four (24) 100/10Mbps Switch ports.
Store-and-Forward technology.
Auto-Negotiation support for each TP port.
IEEE 802.3x Flow-Control support for Full-Duplex operation.
Back-Pressure support for Half-Duplex operation.
Bridging capability for 100Mbps and 10Mbps segments.
All ports support Auto-MDIX function.
2.3

Front Panel

For 19 inches case

2.3.1 100/10Mbps TP Ports

Each 100/10Mbps TP port provides an Auto-Negotiation function that senses for the attached device's maximum operating
speed and automatically sets the Switch to operate at that speed. Users only need to connect a network device into any TP
port.

2.3.2 Cabling

10Mbps - When transmitting at 10Mbps Category 3, 4 or 5 TP cabling with RJ-45 sockets can be used.
100Mbps -To transmit at 100Mbps requires Category 5 TP cabling.
Port Type
10BASE-T
100BASE-TX
Note: Category 5 TP cable is recommended whenever installing new cabling.

2.3.3 Status LEDs

The Switches come with a complete range of LEDs. The table below lists each LEDs name, color and a brief description of its
function.
Name
Color
Function
Pwr
Green
Lit: Power "On"
LINK/ACT
Green
Lit: When the port has a valid physical connection with
another device.
Blinks: When the port is sending or receiving data (Activity).
FD/COL
Amber
Lit: When port is set to Full-Duplex mode.
Blinks: When a collision is detected, when the port is in
Half-Duplex mode.
2.4

Rear Panel

For 19 inches case

2.4.1 Power Socket

The Power Socket is designed to be used with the power cord included in the product package.
Attach the female end of the cord to the power connector on the back panel.
Attach the male end of the cord to a grounded power outlet.

2.4.2 Fan

Note: Please keep the fan area clear, so that the cooling function is not impaired.
Cable Type
Category 3, 4 or 5 TP
Cat.5 TP
4
Connector
RJ-45
RJ-45

Advertisement

Table of Contents
loading

Table of Contents