Sony DVP-NC600 Operating Instructions Manual page 67

xAUDIO DRC (Dynamic Range
Control) (DVD only)
Makes the sound clear when the volume is
turned down when playing a DVD that has
the AUDIO DRC function. This affects the
output from the following jacks:
– LINE OUT L/R (AUDIO) 1/2 jacks
– DIGITAL OUT (COAXIAL or OPTICAL)
jack only when "DOLBY DIGITAL" is set
to "D-PCM" in "DIGITAL OUT" (page
67).
STANDARD Normally, select this position.
TV MODE Makes the low sounds clear
even if you turn the volume
down. It is especially
recommended when you listen
to the sound using the speakers
of the TV.
WIDE
Gives you the feeling of being at
RANGE a live performance. When you
use high quality speakers, it is
even more effective.
xDOWNMIX (DVD only)
Switches the mixing down methods when
you play a DVD on which rear signal
components such as LS, RS, or S are
recorded in Dolby Digital format. For details
on the rear signal components, see
"Changing the Sound" (page 49). This
function affects the output of the following
jacks:
– LINE OUT L/R (AUDIO) 1/2 jacks
– DIGITAL OUT (COAXIAL or OPTICAL)
jack when "DOLBY DIGITAL" is set to
"D-PCM" in "DIGITAL OUT" (page 67).
DOLBY Select this when the player is
SUR- connected to an audio component
ROUND that conforms to Dolby Surround
(Pro Logic). The output signals
which reproduce the Dolby
Surround effect are downmixed
to 2 channels.
Downloaded From Disc-Player.com Sony Manuals
NORMAL
Select this when the player is
connected to an audio component
that does not conform to Dolby
Surround (Pro Logic). All of the
output signals are downmixed to
2 channels without the Dolby
Surround (Pro Logic) effect.
xDIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (COAXIAL or OPTICAL)
jack.
ON Normally, select this position. When
you select "ON," set "DOLBY
DIGITAL" and "DTS." For details on
setting these items, see "Setting the
digital output signal."
OFF The player does not output the audio
signals via the DIGITAL OUT
(COAXIAL or OPTICAL) jack. The
influence of the digital circuit upon
the analog circuit is minimal.
Setting the digital output signal
Switches the method of outputting audio
signals when you connect the following
component using a coaxial digital or optical
digital cord via the DIGITAL OUT
(COAXIAL or OPTICAL) jack.
– Amplifier (receiver) with digital input jack
– Amplifier (receiver) with a built-in DTS or
DOLBY DIGITAL decoder
– MD or DAT deck
For connection details, see page 20.
Select "DOLBY DIGITAL" and "DTS" after
setting "DIGITAL OUT" to "ON."
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
OFF
STANDARD
DOLBY SURROUND
ON
D-PCM
OFF
continued ,
67