Advertisement
5
4
3
2
1
11
NOTE: The model shown in the manual is for reference only. Your model may differ slightly.
f
IllIng
1. T urn Steam Lever to
2. R aise the Water Fill Hole Cover. Hold the iron at a 45 degree angle and use any easy-pour measuring cup to fill
the water reservoir with tap water through the water fill hole. Do not fill water reservoir beyond maximum fill line.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. Hot metal parts, hot water and
steam can cause injuries.
1. Ensure Steam Lever is turned to the
2. Plug the cord into a 120-Volt AC outlet.
3. T urn Fabric Select Setting to desired setting. Allow iron to heat for 2 minutes on its heel rest on a stable, protected
surface.
NOTE: While Steam Lever is turned to the
MIST
features, as long as the Fabric Select Setting is set to wool, cotton, or linen. Water reservoir must be at least
TM
¼ full of water.
1. Fill Water Reservoir and plug the cord into a 120-Volt AC outlet.
2. T urn the Fabric Select Setting to desired setting. Allow the iron to heat for 2 minutes on its heel rest on a stable,
protected surface. Turn Steam Lever to desired setting.
IMPORTANT: When not ironing, always set the Steam Lever to
S
m
tm
pray
ISt
wrinkles from heavy fabrics and for setting creases.
TO USE: Press the Spray Mist
S
S
hot of
team
wrinkles. You can use this feature while Dry or Steam ironing as long as the Fabric Select Setting is set to wool,
cotton, or linen. The water reservoir must be at least ¼ full of water.
TO USE: Place the iron on top of the wrinkle and press the Shot of Steam
burst of steam. The Shot of Steam
NOTE: Shot of Steam pump may require priming for initial use. To prime simply push the button firmly 10-15 times
repetitively.
f
6
13
7
10
8
9
W
r
ater
eServoIr
(Dry) and Fabric Select Setting to Off. Unplug.
d
ry
(Dry) setting.
(Dry) setting, you may still use the SHOT OF STEAM
S
team
S
pecIal
f
eature
is a powerful water spray mist that dampens the fabric to aid in removing
button firmly.
TM
f
®
eature
provides an extra burst of steam for deep penetration of stubborn
feature may be used continuously in approximately 3-second intervals.
®
eatureS
1.
SPRAY MIST™ Nozzle
2.
Water Fill Hole
3.
Steam Lever
4.
SHOT OF STEAM
5.
Reset Button and Power Light
6.
Handle
7.
Fabric Select Setting
8.
S elf Clean Button
9.
S ee-Through Water Reservoir/ Maximum Fill Line
10.
Soleplate
12
11.
Storage Strip
12.
Cord Wrap (underneath)
13.
Power Cord
(use tap water)
I
ronIng
I
ronIng
(Dry) and the Fabric Select Setting to OFF.
f
eatureS
button each time you would like an extra
®
and SPRAY MIST™ Buttons
®
Indicator (select models only)
®
or SPRAY
®
Advertisement
