Charging System - E-TON Sport 150 Service Manual

E-TON

CHARGING SYSTEM

Charging wire diagram
Current Leakage Inspection
Turn the main switch to OFF position, and
remove the negative cable terminal (-) from
the battery.
Connect an ammeter between the negative
cable terminal and the battery negative
terminal (as shown on left diagram).
Caution
z In the current leakage test, set the current
range at larger scale, then gradually
decrease to the lower scale as the test
process goes to avoid possible damage to
the ammeter and the fuse.
z Do not turn the main switch to "ON"
position during test.
If the leaked current exceeds the specified
value, it may indicate a short circuit.
Allowable current leakage: Less than 1
mA.
Disconnect each cable one by one and take
measurement of the current of each cable to
locate the short circuit.
Copyright ©2008-2009 ETON America, all rights reserved.
16. ELECTRICAL EQUIPMENT
ground
wire
Battery(-) terminal
16-5