Saeco Intuita HD8750 User Manual page 49

Machine actions
The machine takes a long time to warm
up or the amount of water dispensed
from the wand is too little.
The brew group cannot be removed.
There is a lot of ground coff ee under
the brew group.
The machine grinds the coff ee beans
but no coff ee comes out.
(see note)
Coff ee is too weak.
(see note)
Coff ee is brewed slowly.
(see note)
Coff ee leaks out of the dispensing
spout.
Milk does not froth.
Frothed milk is too cold.
Causes
The machine circuit is clogged by limescale. Descale the machine.
The brew group is out of place.
The coff ee grounds drawer is inserted.
Coff ee is not suitable for automatic machines. It may be necessary to change the type of coff ee
There is no water.
The brew group is dirty.
The circuit is not primed.
This might occur when the machine is
automatically adjusting the dose.
The dispensing spout is dirty.
This might occur when the machine is
automatically adjusting the dose.
The coff ee grind is too fi ne.
The circuit is not primed.
The brew group is dirty.
The dispensing spout is clogged.
The Automatic Milk Frother is inserted too
deep. No milk is being suctioned.
The cups are cold.
Note:
These problems can be considered normal if the coff ee blend has been
changed or if the machine has just been installed. In this case wait until the
machine performs a self-adjusting operation as described in the "Saeco
Adapting System" chapter.
ENGLISH
Solutions
Turn on the machine. Close the service door. The
brew group automatically returns to the initial
position.
Remove the coff ee grounds drawer before
removing the brew group.
or the coff ee grinder settings.
Fill the water tank and prime the circuit (see "Us-
ing the Machine for the First Time" chapter).
Clean the brew group (see the "Weekly Cleaning
of the Brew Group" chapter).
Prime the circuit (see "Using the Machine for the
First Time" chapter).
Brew a few cups of coff ee as described in the
"Saeco Adapting System" chapter.
Clean the dispensing spout.
Brew a few cups of coff ee as described in the
"Saeco Adapting System" chapter.
Change coff ee blend or adjust the grind as
explained in the "Adjusting the Coff ee Grinder"
chapter.
Prime the circuit (see "Using the Machine for the
First Time" chapter).
Clean the brew group ("Weekly Cleaning
of the Brew Group" chapter).
Clean the dispensing spout and its holes.
Leave the Automatic Milk Frother to cool down.
Move it slightly downwards. Reposition it in its
correct seat.
Preheat the cups with hot water.
47