Saeco Intuita HD8750 User Manual page 43

Note:
The descaling cycle may be paused by pressing the "
To resume the cycle, press the "
empty the container or to leave the machine unattended for a short time.
9 When the descaling solution is fi nished, the "
" " button blinks.
10
Empty the container.
11 Remove the water tank, rinse it and fi ll it up to the MAX level with fresh
water. Place it back into the machine.
12
Empty the drip tray and place it back. Put the container back under
both the steam/hot water wand and the dispensing spout.
13 Press the blinking "
14
When the rinse cycle is complete, the "
button blinks.
15
Repeat steps 10 – 14; then continue to step 16.
16 At the end of the 2 nd rinse cycle, the "
light stays on; the descaling process is complete.
Note:
If the tank is not fi lled up to the MAX level for the rinse cycle, the "
light keeps on blinking and another cycle may need to be performed;
repeat steps 10 to 14.
" button again. This allows you to
" light turns on and the
" button to perform the rinse cycle.
" light turns on and the "
" light turns off and only the
ENGLISH
41
" button.
"
"