Table of Contents
Advertisement
Port status LEDs
The following table provides LED port information. If an HP AdvanceStack
8U/16U SNMP module is installed, additional LED states may be observed.
For information about the hub LEDs when an HP AdvanceStack 8U/16U
SNMP Module is installed, see the manual accompanying the module.
LED
State
AUI/Xcvr
On
An optional HP Transceiver Module is properly installed in the hub's
Port (green)
front panel slot.
Off
An HP Transceiver Module is not installed.
Slow
The HP Transceiver Module port has auto-partitioned. See
Flash*
"Auto-Partitioning" later in this chapter.
Twisted-pair
On
Link beat is detected from the attached node.
Port (green)
Off
The port is not receiving the link beat signal from the attached node.
Slow
The port has been auto-partitioned. See "Auto-Partitioning" later in
Flash*
this chapter.
* The slow flash is approximately once every 1.5 seconds.
AUI/Xcvr Slot
The AUI/Xcvr Slot is used to add an HP Transceiver Module. For more
information, see the "Install Add-in Modules" section in chapter 1.
Back of the hub
The management slot is used to add an HP AdvanceStack 8U/16U SNMP
Module. For more information, see the "Install Add-in Modules" section in
chapter 1.
Hub Reference
Meaning of LED
3-3
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
