Wall Mounting - HP AdvanceStack Hub-16U Installation And Reference Manual

Installing the Hub

Wall Mounting

1. Using a flat-headed or Torx T-10 screwdriver, attach the mounting
Mounting
bracket
Flat on wall
Mounting
bracket
Straight out from wall
10-mm M3
screws
Table Mounting. To place the hub on a table or other horizontal surface, no
special tools are necessary. Attach the self-adhesive rubber feet (included in
the accessory kit) to the bottom of the hub. Be certain to pick a sturdy table
in an uncluttered area. You may want to secure the hub's cables to the leg of
the table to prevent people from tripping over them.
1-10
brackets to the hub with 10-mm M3 screws included in the accessory
kit. Then attach the hub to a wood surface (minimum 1/2-inch
plywood or equivalent) with 5/8-inch number 12 wood screws
included in the accessory kit with a Phillips crosshead screwdriver.
10-mm M3
screws