Rack Or Cabinet Mounting - HP AdvanceStack Hub-16U Installation And Reference Manual

Rack or Cabinet Mounting

W a r n i n g
The rack or cabinet should be adequately secured to prevent it
from becoming unstable and/or falling over.
1. Using a flat-headed or Torx T-10 screwdriver, attach the mounting
2. Position the hub in the rack or cabinet and slide it up or down until
3. Then attach the hub to the rack with 5/8-inch number 12-24 screws
Front facing out
5/8-inch number
12-24 screws
brackets to the hub with 10-mm M3 screws (included in the
accessory kit). Note that the hub's case and the mounting brackets
are designed to allow you to rack mount the hub with either the back
or the front facing out.
the rack holes line up with the bracket holes.
included in the accessory kit with a Phillips crosshead screwdriver.
(Some cabinets require number 10-32 screws instead, available as
part number 2680-0302. Make sure you have screws that fit your
cabinet or rack before mounting the hub.)
10-mm M3
screws
Installing the Hub
Mounting
bracket
1-9