HP AdvanceStack Hub-16U Installation And Reference Manual page 26

Installing the Hub
In the following illustration, the first hub is connected to two end nodes and
to a second hub.
Hub attached to Port
16: switch in MDI
position and
straight-through cable
is used.
ThinLAN Connections
With an HP ThinLAN Transceiver Module for 10Base2 networks, you can
connect your hub or a stack of hubs to a thin LAN network. The following
illustration shows a hub with an HP ThinLAN Transceiver Module.
50-ohm
terminator
thin LAN
cable
1-14
Up to 100 meters
PC attached to Port 16:
switch in MDI-X
position and
straight-through cable
is used.
HP J2608A ThinLAN
Transceiver Module installed in the AUI/Xcvr
Slot