Connecting Hubs To Network Backbones - HP AdvanceStack Hub-16U Installation And Reference Manual

You can connect up to 30 hubs together on a common ThinLAN segment.
The ThinLAN segment can include a computer attached to a hub at one end
of the segment that can communicate with a computer attached to another
hub at the other end of the segment. By using the BNC port on the module,
the maximum repeater hop-count increment through the entire segment is
only two. The following illustration shows you how to connect three hubs
together from one ThinLAN port to another.
50-ohm
terminator
ThinLAN coax
connecting the
hubs together
50-ohm
terminator
N o t e
Each ThinLAN cable segment must be terminated using a 50-ohm
terminator at each end. In the illustration above, a 50-ohm terminator is
placed at each end of the cable segment.

Connecting Hubs to Network Backbones

Connecting the Hub-16U to a ThinLAN Backbone
The optional ThinLAN Transceiver Module has a BNC 10Base2 port that can
be used to connect your hub to a ThinLAN backbone.
Installing the Hub
Hub-16U
Hub-16U
HP AdvanceStack
10Base-T Hub-24
1-15