Special Requirements - Honda EU3000i Handi Owner's Manual

Special Requirements

Keep all cooling holes open and clear of debris, mud, water, etc.
Cooling holes are located on the front panel, rear panel, and the bottom
of the generator. If the cooling holes are blocked, the generator may
overheat and damage the engine, inverter, or windings.
Do not lay the generator on its side when moving, storing, or operating
it. Oil may leak and damage the engine or your property.
There may be Federal or State Occupational Safety and Health
Administration (OSHA) regulations, local codes, or ordinances that
apply to the intended use of the generator. Please consult a qualified
electrician, electrical inspector, or the local agency having jurisdiction.
• In some areas, generators are required to be registered with local
utility companies.
• If the generator is used at a construction site, there may be additional
regulations that must be observed.
OPERATION
39