Rem Pe Ие Meroе; Connections To A Building Electrical System; Теd De; Special Requirements - Honda EZ3500 Owner's Manual

GENERATOR USE
CONNECTIONS TO A BUILDING ELECTRICAL SYSTEM
Connections for standby power to a building electrical system must be
made by aqualified electrician. The connection mustisolatethe generator
power from utility power, and must comply with all applicable laws and
electrical codes. Atransfer switch, which isolates generator power from
utility power, is available through authorized Honda generator dealers.
Å WARNING
Improper connections to a building electrical system can allow elec-
trical current from the generator to backfeed into the utility lines. Such
backfeed may electrocute utility company workers or others who con-
tact the lines during a power outage, and the generator may explode,
burn, or cause fires when utility power is restored. Consult the utility
company or a qualified electrician.
GROUND SYSTEM
Honda portable generators have a system ground that connects
generator frame components to the ground terminals in the AC output
receptacles. The system ground is notconnected to the AC neutral wire.
If the generator is tested by a receptacle tester, it will not show the same
ground circuit condition as for a home receptacle.
SPECIAL REQUIREMENTS
There may be Federal or State Occupational Safety and Health
Administration (OSHA) regulations, local codes, or ordinances that
apply to the intended use of the generator. Please consult a qualified
electrician, electrical inspector, or the local agency having jurisdiction.
* |n some areas, generators are required to be registered with local
utility companies.
* Ifthe generator is used at a construction site, there may be additional
regulations which must be observed.
15