Microprocessor Control; Wireless Remote Controller - Mitsubishi Electric MS-C18TV-E1 WH Service Manual

9

MICROPROCESSOR CONTROL

WIRELESS REMOTE CONTROLLER

Signal transmitting section
Operation display section
OPERATE /STOP
(ON /OFF)button
FAN SPEED CONTROL button
OPERATION SELECT button
ECONO COOL button
RESET button
INDOOR UNIT DISPLAY SECTION
Operation Indicator lamp
The operation indicator at the right side of the indoor
unit indicates the operation state.
Operation Indicator
Indication Operation state
This shows that the
air conditioner is
operating to reach
the target temperature.
Please wait until the
target temperature is
obtained.
This shows that the
room temperature is
approaching the
target temperature.
PM
AM
TOO TOO
ON/OFF
WARM COOL
TEMPERATURE buttons
CLOCK
PM
AM
TOO TOO
ON/OFF
WARM COOL
FAN STOP
I FEEL COOL
OFF-TIMER button
VANE START
FAN DRY
ON-TIMER button
MODE HR.
HR. button
MIN. button
ECONO COOL MIN.
(TIME SET button)
RESET CLOCK
CLOCK SET button
VANE CONTROL button
lighting
not lighting
Difference
between set
temperature
and room
temperature
Approx. 2 :
or more
Approx. 2 :
or less
MS-C18TV -
E1
MS-C24TV -
E1
Once the operation mode are set, the same operation mode
can be repeated by simply turning the
OPERATE/STOP(ON/OFF) button ON.
Indoor unit receives the signal with a beep tone.
When the system turns off, 3-minute time delay will operate to
protect system from overload and compressor will not restart
for 3 minutes.
9-1. "I FEEL CONTROL" (
(1) Press OPERATE/STOP(ON/OFF) button on the remote
controller. OPERATION INDICATOR lamp of the indoor
unit turns on with a beep tone.
(2) Select "I FEEL CONTROL"(
TION SELECT button.
(3) The operation mode is determined by the room tempera-
ture at start-up of the operation.
Initial room temperature
25: or more
more than 13:,
less than 25:
Once the mode is fixed, the mode does not change by
room temperature afterwards.
Under the ON-TIMER (
determined according to the room temperature at the set
time the operation starts.
When the system is stopped on the remote controller,
and restarted within 2 hours in "I FEEL CONTROL" (
mode, the system operates in previous mode automati-
cally regardless of the room temperature.
Example
Previous operation
COOL mode of
"I FEEL CONTROL" or
COOL mode
When the system is restarted after 2 hours and more,
the operation mode is determined by the room tempera-
ture at start-up of the operation.
Operation timer chart
Example
Previous operation
COOL mode of
"I FEEL CONTROL"
or COOL mode
20
) OPERATION
) mode with the OPERA-
mode
COOL mode of
"I FEEL CONTROL"
DRY mode of
"I FEEL CONTROL"
) operation, the mode is
Restart
COOL mode of
"I FEEL CONTROL"
Restart
COOL or DRY mode of
"I FEEL CONTROL" that
determined by room
temperature at start-up
of the operation.
)