Table of Contents
Advertisement
OPERATION
1. Turn on the wall switch to activate the light, the light is now under nighttime mode: light and alarm work at night
only.
NOTE: Allow for approximately 30 seconds warm-up time before the sensor resumes normal activity.
2. To test, walk through the sensor's detection area.
3. Movement will activate the sensor and turn the light on, the light will turn the face to the detected zone for
approx. 3 minutes.
4. After the light is activated, keep out of detection area and the light will switch off automatically after 3 minutes.
The light will be activated again when detecting any movement.
If there is continuing movement in the detection zone, the light will stay on until movement ceases. (after 3
minutes)
LAMP REPLACEMENT
To isolate the unit, first switch off the unit from the mains power. Allow bulb to cool before attempting to remove it.
Unscrew the lamp cover and take the old lamp out and replace with new one, close the lamp cover and tighten the
screws.
WARNING: This fitting will become hot when in use. Allow bulb to cool before touching. Never touch the bulbs
with your bare hands. Always use a clean cloth when handling the bulbs.
NOTE: THE INTELLIGENT MOTION SENSOR TRACKING LIGHT IS DESIGNED TO ILLUMINATE W HEN THE DETECTION
ARE A IS ENTERED BY A PERSON AND W ILL DETECT MOVING HE AT SOURCE.
IMPLIED THAT IT W ILL PROVIDE TOTAL SECURITY OR PREVENT ILLEG AL ENTRY.
CLEANING
Before Cleaning make sure that the power is cut off and allow to cool before commencing.
•
Care must be taken while cleaning to avoid scratching the fitting and glass. A soft cloth or a fine hair brush
•
should be used with a non-abrasive cleaner.
DO NOT use solvents or abrasive cleaners on any part of the Nightwatcher.
THERE IS NO GUAR ANTEE
6
Advertisement
Table of Contents
