Table of Contents
Advertisement
MOUNTING THE FITTING
To ensure correct operation of the sensor, mount the luminaire that traffic passes across the detector.
INSTALLATION AND WIRING INSTRUCTIONS
Remove the inset back mounting box from the luminaire. Fit the inset back mounting box onto the wall and tighten
the screws at a height that ensures adequate coverage of the area by the infrared detector. The minimum
installation height is 2 meters. And the maximum height is 3 meters.
NOTE: DO NOT REMOVE THE TAPE UNTIL YOU FINISH THE INSTALLATION. IF THE TAPE COMES OFF
THE LIGHT, PLEASE REPLACE IT OR HOLD THE LIGHT HEAD TO AVOID SWIVELING AND DAMAGE THE
PRODUCT.
WIRING INSTRUCTIONS
Feed the cable through the back mounting box and bush the
cable entry to avoid abrasion to the cable.
Connect the earth wire to the connector opposite the
green/yellow cable.
Connect the brown phase conductor active to the connector
opposite the brown cable and tighten the screws.
Connect the blue neutral conductor to the connector opposite
the blue cable and tighten the screws.
Check that all connections are correct and tight, as any
misconnections will damage the detector.
Re-fit the fitting to the back mounting box
GOOD SENSITIVITY
TOP VIEW
LESS SENSITIVITY
4
Advertisement
Table of Contents
