Summary of Contents for NightWatcher nw1010X
- Page 1 Motion tracking sensor halogen light Installation & operating manual NIGHTWATCHER alarm plus nw1010X Model no:...
-
Page 2: Specifications
INTRODUCTION Congratulations on the purchase of your new Nightwatcher Alarm Plus. Before installation of the unit, please read the operating instructions and safeguards carefully. It is important that you read and follow the instructions in the manual, even if you feel you are familiar with this type of product. -
Page 3: Installing The Bulb
OVERVIEW Push-button 3 motion sensors INSTALLING THE BULB Unscrew the lamp cover of the luminaire and install a 150W J-type lamp. Re-fit the lamp cover and tighten the screws. IMPORTANT: THE INSTALLATION OF THIS FITTING MUST BE DONE BY A QUALIFIED ELECTRICIAN. This fitting must be earthed. -
Page 4: Top View
MOUNTING THE FITTING To ensure correct operation of the sensor, mount the luminaire that traffic passes across the detector. TOP VIEW GOOD SENSITIVITY LESS SENSITIVITY INSTALLATION AND WIRING INSTRUCTIONS Remove the inset back mounting box from the luminaire. Fit the inset back mounting box onto the wall and tighten the screws at a height that ensures adequate coverage of the area by the infrared detector. - Page 5 FUNCTION This light is equipped with 3 motion sensors: zone 1 covers 60 degree, zone 2 covers 100 degrees and zone 3 covers 60 degrees. 220 degrees (maximum) in total for 3 zones. ZONE 2 ZONE 1 ZONE 3 TOTAL DETECTION RANGE When power is first turned on the light will go to self calibration mode for about 1 minute.
-
Page 6: Operation
Care must be taken while cleaning to avoid scratching the fitting and glass. A soft cloth or a fine hair brush • should be used with a non-abrasive cleaner. DO NOT use solvents or abrasive cleaners on any part of the Nightwatcher. -
Page 7: Installing/Replacing Batteries
WIRELESS ALARM OPERATION OVERVIEW Speaker: warning device will make a sound of alarm when the tracking light detects any movement. Low battery indicator: when batteries are going to be out of the power, the indicator will flash in red once per 3 seconds and this product will stop working until new batteries are replaced. -
Page 8: Installation
INSTALLATION Warning device is designed for indoor use, please install it in the house or under the roof of the balcony. Drill a hole on the wall. Ensure the provided wall plug push tightly into position and put the screw in the wall plug. Hang warning device on the screw and ensure it is well secured. -
Page 9: Product Warranty
PRODUCT WARRANTY 1 YEAR REPLACEMENT WARRANTY THIS WARRANTY FORM SHOULD BE Your Nightwatcher Security Light is covered for a RETAINED BY THE CUSTOMER AT ALL Period of 12 months from your TIMES. Date of Purchase. WARNING The Warranty covers faulty parts or workmanship.