Table of Contents
Advertisement
OVERVIEW
INSTALLING THE BULB
Unscrew the lamp cover of the luminaire and install a
150W J-type lamp.
Re-fit the lamp cover and tighten the screws.
IMPORTANT: THE INSTALLATION OF THIS FITTING MUST BE DONE BY A QUALIFIED ELECTRICIAN.
This fitting must be earthed.
Do not mount the luminaire against inflammable surfaces.
The motion detector will not operate correctly if it is installed:
( ) Near the outlet of a central heating boiler
( ) Near air conditioning plant
( ) Pointing directly at moving vehicles
( ) Within sight of reflection from moving water
( ) Where other lamps could shine onto the detector
The maximum rating of this luminaire is 150 Watts. Check that the total load of the circuit including this
luminary does not exceed the rating of the circuit cable.
NOTE: This highly responsive unit may occasionally activate due to rapid environmental changes. Allow for
approximately 30 seconds warm-up time before the sensor resumes normal activity.
3 motion sensors
WARNING ! ! !
BEFORE ATTEMPTING ANY INSTALLATION OR
MAINTENANCE, ENSURE THAT THE
ELECTRICAL SUPPLY IS SWITCHED OFF AND
THE CIRCUIT FUSES REMOVED OR THE
CIRCUIT BREAKER IS IN THE "OFF"POSITION.
Push-button
3
Advertisement
Table of Contents
