Superior BCT2536TMN Installation And Operation Instructions Manual

B-vent natural gas decorative fireplace

Advertisement

Quick Links

P/N 126741-01 Rev. C 10/2014
P126741-01
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This appliance may be installed in an aftermarket permanently located, manufactured home (USA only) or mobile
home, where not prohibited by local codes. This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.
WARNING AVERTISSEMENT AVISO
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
WARNING: If the information in these
instructions is not followed exactly, a fire or
explosion may result causing property damage,
personal injury or death.
— Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call
the fire department.
— Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.
Installation and Operation Instructions
Superior™ B-Vent Natural Gas Decorative Fireplace
Models
PFS
®
US
REPORT NO. F09-155
Installateur : Laissez cette notice avec l'appareil.
Consommateur : Conservez cette notice pour consultation ultérieure.
UNE SURFACE VITRÉE CHAUDE PEUT
CAUSER DES BRÛLURES.
LAISSER REFROIDIR LA SURFACE VITRÉE
AVANT D'Y TOUCHER.
NE PERMETTEZ JAMAIS À UN ENFANT DE
TOUCHER LA SURFACE VITRÉE.
AVERTISSEMENT : Assurez-vous de bien suivre les
instructions données dans cette notice pour réduire au
minimum le risque d'incindie ou d'explosion ou pour éviter
tout dommage matériel, toute blessure ou la mort.
— Ne pas entreposer ni utilizer d'essence ni d'autres
— QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ :
— L'installation et l'entretien doivent être assurés par un
For more information, visit Superiorfireplaces.US.com
BCT2536TMN
BCT2536TMP
vapeurs ou liquides inflammables dans le voisinage
de cet appareil ou de tout autre appareil.
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucan interrupteur. Ne pas vous
servir des téléphones se trouvant dans le bâtiment
où vous trouvez.
• Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incindies.
installateur ou un service d'entretien qualifié ou par le
fournisseur de gaz.
BCT2536TEN
BCT2536TEP
EL VIDRIO CALIENTE
CAUSARÁ QUEMADURAS.
USTED DEBE NUNCA TOCAR
EL VIDRIO CALIENTE.
LOS NIÑOS DEBEN NUNCA
TOCAR EL VIDRIO.

Advertisement

Table of Contents
loading

Summary of Contents for Superior BCT2536TMN

  • Page 1 Installation and Operation Instructions Superior™ B-Vent Natural Gas Decorative Fireplace Models BCT2536TMN BCT2536TEN P/N 126741-01 Rev. C 10/2014 ® BCT2536TMP BCT2536TEP REPORT NO. F09-155 P126741-01 INSTALLER: Leave this manual with the appliance. Installateur : Laissez cette notice avec l’appareil. CONSUMER: Retain this manual for future reference.
  • Page 2: Table Of Contents

    Thank you for your purchase. We appreciate your TABLE OF CONTENTS business! Safety .....................2 Please carefully read and follow all instructions in this manual. Pay Product Identification ..............4 special attention to all warnings and safety information. Local Codes ...................4 Following these safety, care, and operation instructions will help Product Features ................4 ensure many years of dependable and enjoyable service from your Pre-Installation Preparation ............4...
  • Page 3 SAFETY Continued Natural and Propane/LP Gas: Natural and propane/LP gases are This product is intended only as a supplement to your odorless. An odor-making agent is added to these gases. The odor central heating system and is not to be installed as a helps you detect a gas leak.
  • Page 4: Product Identification

    Glass flush wall enclosure or a framed-in corner installation. Door • Models BCT2536TMN and BCT2536TMP are equipped with a Assembly millivolt gas control system that does not require electricity to Log Set operate.
  • Page 5: Glass Panel

    PRE-INSTALLATION PREPARATION Continued PACKAGING AND REMOVAL The BCT2536 series vented decorative gas fireplaces are packaged with the following items: • one box containing a 4 piece log set located on the burner in the Flush with a wall Corner firebox. Installation •...
  • Page 6 PRE-INSTALLATION PREPARATION Continued FRAMING AND FINISHING For available accessories for this fireplace, see Accessories, page 30. If you are using a separate combustible mantel piece, refer to Figures Figure 5, shows typical framing of this fireplace. Figure 6, shows 8 and 9, page 7, for proper height and clearances. You can install a framing for corner installation.
  • Page 7 PRE-INSTALLATION PREPARATION Continued MANTEL CLEARANCES Figure 8 shows projected mantel depths at various heights above top of louver opening. Figure 7, shows minimum allowable distances from various mantel components in relation to both sides of fireplace Stud Wall opening. 2 x 4 Header WARNING: When finishing appliance do not overlap at 1"...
  • Page 8: Installation Precautions

    INSTALLATION PRECAUTIONS VENTING INSTALLATION A 4" B-type venting system must be connected to the appliance for NOTICE: Failure to follow these instructions will void venting to the outside of the building. the warranty. The following section is provided as a guide to install a standard B-type vent installation.
  • Page 9 VENTING INSTALLATION Continued Some codes areas allow the use of existing B-type vent systems if the It is not recommended that this appliance be common vented with and system is at or above the recommended diameter of the flue. existing gas burning appliance. However, if it becomes necessary to common vent the appliance.
  • Page 10 VENTING INSTALLATION Continued CHECKING FOR PROPER VENTING 7. Slide junction box down till mounting tab holes line up and replace inner retaining screw. After completing and checking electrical, gas and vent connections, follow lighting instructions and allow main burner to run for approxi- 8.
  • Page 11: Installating Optional Controls

    INSTALLING OPTIONAL CONTROLS INSTALLING OPTIONAL WIRELESS REMOTE CONTROL - MODEL INSTALLING OPTIONAL WALL MOUNT SWITCH - GWMS2 WRC (Electronic Ignition) 1. Connect one terminal of 15 foot wire from wall switch to male Installing and Activating the Remote Receiver connector on high limit harness. Connect remaining wire terminal to TH terminal on valve.
  • Page 12: Wiring Diagrams

    INSTALLING OPTIONAL CONTROLS Continued WIRING DIAGRAMS NOTICE: This appliance is equipped with a vent safety shutoff switch which will shut down the appliance in case of a venting problem. Do not bypass the vent safety shutoff switch. If the appliance should shut down, have a qualified installer, service agency, or your gas supplier inspect the vent before operating.
  • Page 13: Fireplace Installation

    FIREPLACE INSTALLATION Propane/LP Supply Tank CHECK GAS TYPE Use only the correct type of gas (natural or propane/LP). If your gas supply is not the correct gas type, do not install fireplace. See dealer where you purchased your fireplace for proper gas type fireplace or to purchase gas conversion kit (see Accessories, page 30).
  • Page 14 FIREPLACE INSTALLATION Continued Check your building codes for any special requirements for locating CHECKING GAS CONNECTIONS equipment shutoff valve to fireplaces. WARNING: Test all gas piping and connections, Apply pipe joint sealant lightly to male NPT threads. This will prevent internal and external to unit, for leaks after installing excess sealant from going into pipe.
  • Page 15 FIREPLACE INSTALLATION Continued Equipment Shutoff Valve LOUVER PANELS AND GLASS DOOR Propane/LP CAUTION: Do not operate this fireplace with a bro- Supply Tank ken glass door panel or without the glass door panel securely in place. For replacement part information see Replacement Parts, page 30.
  • Page 16 FIREPLACE INSTALLATION Continued 4. Break ember material into quarter sized pieces and place a single layer along the full length of ember tray to hide bottom edge of Spring Clips base log (see Figure 29). 5. Replace glass door and louver panels (see Removing/Replacing Glass Door, page 15).
  • Page 17: Operating Fireplace

    OPERATING FIREPLACE MANUAL IGNITION SYSTEM to OFF and call your service technician or gas supplier. FOR YOUR SAFETY 9. Turn on all electric power to fireplace. READ BEFORE LIGHTING 10. Turn gas control knob counterclockwise to ON. 11. To leave pilot lit and shut off burners only: turn control knob WARNING: If you do not follow these instructions clockwise to the PILOT position.
  • Page 18 OPERATING FIREPLACE Continued ELECTRONIC IGNITION SYSTEM LIGHTING TO TURN OFF GAS INSTRUCTIONS TO APPLIANCE 1. STOP! Read the safety information, page 20. 1. Turn off wall switch. 2. Turn off all electric power to appliance if service is to be per- 2.
  • Page 19 OPERATING FIREPLACE Continued OPTIONAL HAND-HELD OPTIONAL GWMS2 REMOTE OPERATION ON/OFF WALL MOUNTED SWITCH Note: All remote control accessories must be purchased separately WARNING: Do not connect the appliance gas con- (see Accessories, page 30). Follow instructions included with the trols to a 120 VAC power source. Damage or injury remote control.
  • Page 20: Inspecting Burners

    INSPECTING BURNERS BURNER FLAME PATTERNS Check pilot flame pattern and burner flame patterns often. Burner flames will be steady, not lifting or floating. Flame patterns PILOT ASSEMBLY will differ from unit to unit and will vary depending on installation The pilot assembly is factory preset for proper flame height. Altera- type and weather conditions.
  • Page 21: Cleaning And Maintenance

    CLEANING AND MAINTENANCE WARNING: Turn off fireplace and let cool before CAUTION: Do not vacuum if pieces are hot. cleaning. Use only the tempered glass door replacement intended for this fireplace (see Replacement Parts, page 30 for detail on ordering). CAUTION: You must keep control areas, burn- No substitutions may be made.
  • Page 22: Troubleshooting

    TROUBLESHOOTING WARNING: Turn off fireplace and let cool before servicing. Only a qualified service person should service and repair fireplace. CAUTION: Never use a wire, needle or similar object to clean ODS/pilot. This can damage ODS/pilot unit. Note: All troubleshooting items are listed in order of operation. The two most common causes of a malfunctioning gas appliance are: 1.
  • Page 23 TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Burner does not light after pilot is lit or cycles 1. Burner orifice clogged 1. Clean burner (see Cleaning and Maintenance, during operation. page 21) or replace burner orifice 2. Inlet gas pressure is too low 2.
  • Page 24 TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Electronic Ignition Models Only Ignitor will not 1. No gas supply, or shutoff valve is OFF 1. Check to see if you have gas supply and that spark or pilot will not light equipment shutoff valve is opened 2.
  • Page 25: Specifications

    Use a minimum one layer of smaller ember pieces to achieve best glowing effect over visible areas SPECIFICATIONS BCT2536TMN BCT2536TEN • Maximum Input Rating: 18,000 Btu/hr • Maximum Input Rating: 18,000 Btu/hr • Gas Type: Natural • Gas Type: Natural •...
  • Page 26: Parts

    PARTS FIREPLACE ASSEMBLY FOR MODELS BCT2536TMN, BCT2536TMP, BCT2536TEN AND BCT253T6EP CATALOG NO. MODEL F0847 BCT2536TMN F0848 BCT2536TMP F0849 BCT2536TEN F0850 BCT2536TEP Superiorfireplaces.US.com 126741-01C...
  • Page 27 30 of this manual. WARNING: Contact an IHP dealer to obtain any of these parts. Never use substitute materials not approved by IHP. Use of non-approved parts can result in poor performance and safety hazards. BCT2536TMN BCT2536TMN BCT2536TEN BCT2536TEN NO.
  • Page 28 PARTS BURNER ASSEMBLY FOR MODELS BCT2536TMN, BCT2536TMP, BCT2536TEN AND BCT2536TEP CATALOG NO. MODEL F0847 BCT2536TMN F0848 BCT2536TMP F0849 BCT2536TEN F0850 BCT2536TEP Piezo Ignition Models Only Electric Ignition Models Only Superiorfireplaces.US.com 126741-01C...
  • Page 29 30 of this manual. WARNING: Contact an IHP dealer to obtain any of these parts. Never use substitute materials not approved by IHP. Use of non-approved parts can result in poor performance and safety hazards. BCT2536TMN BCT2536TMP BCT2536TEN BCT2536TEP...
  • Page 30: Replacement Parts

    REPLACEMENT PARTS SERVICE HINTS Note: Use only original replacement parts. This will protect your When Gas Pressure Is Too Low warranty coverage for parts replaced under warranty. • pilot will not stay lit • burners will have delayed ignition PARTS UNDER WARRANTY •...
  • Page 31: Warranty

    THE WARRANTY Innovative Hearth Products ("IHP") 20 Year Limited Warranty warrants your Superior™ Brand gas fireplace, Stove or Insert ("Product") to be free from defects in materials and workmanship at the time of manufacture. The Product body and firebox carry the 20 Year Limited Warranty. Ceramic glass carries the 20 Year Limited Warranty against thermal breakage only.
  • Page 32 KEEP THIS WARRANTY Model (located on product or identification tag) ____________________________________ Serial No. (located on product or identification tag) _________________________________ Date Purchased _______________________________ Keep receipt for warranty verification. IHP reserves the right to make changes at any time, without notice, in design, materials, specifica- tions, prices and also to discontinue colors, styles and products.

This manual is also suitable for:

Bct2536tmpBct2536tepBct2536ten

Table of Contents