Replacing Cap O'ring; Winterizing - Sani king PERFORM-MAX 910 Instruction Manual

Replacing Cap O'Ring

1. Hold cap in front of you
upside down with the o'ring
groove facing up. Place one
end of o'ring into cap groove
at the point closest to you.
Hold o'ring down with the
thumb and forefinger of one
hand.
Replacing Knob
To replace, simply unscrew
old knob and replace with the
new one.
Side of Perform-Max
(Models 910 and 930)

Winterizing

1. Operate Perform-Max
until empty of all chemical.
When empty, set control
dial to maximum and let
run empty for 24 hours.
3. Remove cap.
2. Take hold of the far end of
the o'ring with the thumb and
index finger of the other hand.
Roll o'ring slightly back
towards you
Front of Perform-Max
(Models 910 and 930)
2. Turn pump off.
C Y C LE
R
M e te
re d Po
ol Purifier
S E RI ES
4. Unscrew drain knob in front of Models 910 and 930 and in
back of Models 940, 960, and 980. Allow all water to drain.
as you stretch the o'ring into
the remainder of the cap
groove.
Back of Perform-Max
(Models 940, 960 and 980)
3. Unscrew side knob on Models 910 & 930 or cap knob on
Models 940, 960 & 980 to relieve pressure.
OTHER COPY?
SILICONE
LU BRICANT
COPY
COPY
OP
COPY
3. Lubricate o'ring by
squeezing a little silicone
lubricant that came with your
Perform-Max directly on the
o'ring. Use your finger to
spread over surface. This
allows for longer o'ring life and
prevents breakdown of the
rubber or a sticky residue that
often occurs with other
lubricants. Especially avoid
petroleum based lubricants.
Cap of Perform-Max
(Models 940, 960 and 980)
Ne
Wate
®
6. Replace the cap and knobs
loosely.
15