Replacing Control Dial O'rings - Sani king PERFORM-MAX 910 Instruction Manual

Perform-Max Maintenance
Replacing the Control Dial O'Rings for Above Ground Perform-Max
Locking Pin
(Back of
Perform-Max)
Control
Dial
PORT
(Front of
Perform-Max)
1.To replace, locate the con-
trol dial locking pin in the
back of the Perform-Max.
E R F
O R M-
M A
P O
O L S
A NI TIZER
Replacing the Control Dial O'Ring Kit for Inground Perform-Max
1. Using a needle nose pliers,
find the snap ring tail located
at approximately the five
o'clock position under the
control dial.
OTHER COPY?
SILICONE
LUBRICANT
COPY
COPY
OP
COPY
4. Carefully replace the rubber
o'ring without stretching it.
Squeeze a little silicone lubri-
cant that came with your Per-
form-Max directly on the
o'ring and spread it over o'ring
surface with your finger.
14
2. Depress tab at end of
locking pin with a pen or
screwdriver and pull pin
out of valve.
5. Carefully Insert control dial
back into housing.
2. Pull down and out
of the groove.
PO OL
SA NITI ZER
5. Push control dial
completely into the housing
and turn the dial to
setting 2.
E R F
O R M-
M A
P O
O L S
A NI TIZER
3. Turn control dial back
and forth as you pull it
out of the housing.
3. Using a large screwdriver,
loosen the control dial by
carefully prying each side
a little at a time.
6. Insert the non-lipped end
of snap ring into the groove
opening beginning at the
5 o'clock position and push
it up so that it threads itself
around the control dial.
OTHER COPY?
SILICONE
LUBRICANT
COPY
COPY
OP
COPY
4. Replace both o'rings.
Please note: the back o'ring
has a loose fit in the groove.
Upon replacement squeeze
a little silicone lubricant that
came with your Perform-Max
on o'ring. Use your finger to
spread over surface.
6. Replace locking pin by
pushing it through the slots
on the valve until it locks into
place.
PO OL
SA NITI ZER
Then pull dial out of the
housing.
7. Using a small screwdriver
or pointed tool to help guide
it, make sure the snap ring
stays in the groove as it is
inserted.