Introduction. Congratulations and thank you for choosing our Integrated Cooker Hood. We are sure you will find your new integrated cooker hood a pleasure to use. Before you use your cooker hood we recommend that you read through the whole user manual, which provides the description of the cooker hood and its functions.
Safety Instructions. Keep young children from using, playing with or tampering with this appliance. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Electrical Requirements Any permanent electrical installation must comply with the latest I.E.E. Regulations and local electricity company regulations. For your own safety a qualified electrician or contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC) should undertake the electrical installation.
Mounting of the Cooker Hood Between Two Hanging Cupboards Open the front panel and push the two catches (A) upwards and remove the grille and grease filter. Pull the locking pin B, on both sides of the front panel, until they stop, and pull the front panel forward until it is released from its guide rails.
Extraction Mode or Recirculation Mode. Your new cooker hood can be installed either for recirculation or extraction through an outside wall. NOTE: The cooker hood is more efficient in the extraction mode. Installation for Recirculation. If it is not possible to exhaust through an outside wall the cooker hood can be fitted with a carbon filter (optional extra) to remove any odours and the air is then re-circulated.
Using Your Cooker Hood. The light and the fan motor will not operate if the outer cover is in the closed position. Pull open the outer door and the control switches can be seen on the left side panel. The upper slider switch will turn the lamps on and off. The lower slider switch will turn the extractor fan motor on and off.
Maintenance and Troubleshooting. Lamps fail to operate A replacement is possible necessary, but first check that the lamp is correctly fitted into its holder. Remember that the lamps are not covered by our guarantee. Remember to disconnect the mains electricity supply before replacing the lamps.
Page 11
The Manufacturer’s Authorised Repairer must be contacted if service is required during the period of this guarantee. Customer Service To arrange an in guarantee service call, please contact customer services on the following numbers. UK and N.Ireland T: 0844 8001128 E: uksupport@apelson.co.uk www.myspareparts.co.uk Republic of Ireland (Eire) T: 01 4475261 E: uksupport@apelson.co.uk...
Page 12
Need a spare part or accessory? www.myspareparts.co.uk uksupport@apelson.co.uk Customer Service Number:0844 8001128 Ver 04...
Need help?
Do you have a question about the IH60SV and is the answer not in the manual?
Questions and answers